Friday, August 30, 2013

Change AutoCAD 2014 from Network license to Standalone

AutoCAD 2014 and its verticals can easily be changed between Network, Standalone and Multiseat Standalone licensing with a small registry hack.

Note: This feature is not officially supported by Autodesk and always be careful when editing the registry, backup if needed.

Start the Registry Editor and the registry location is HKEY_LOCAL_MACHINE\SOFTWARE\Autodesk\AutoCAD\R19.1 and then depending on AutoCAD vertical look in ACAD-D001 for AutoCAD 2014 or for example ACAD-D004 for AutoCAD Architecture 2014. Finally in AdLM there is Type that can be changed to any of the values 1, 2 or 3 as seen below.

1 – Network

2 – Standalone

3 – Multiseat Standalone

Switching license type in Inventor, Inventor LT and Inventor Professional is also possible:

Inventor release 2012:
HKEY_LOCAL_MACHINE\SOFTWARE\Autodesk\Inventor\RegistryVersion16.0\LicenseMode

Inventor release 2013:
HKEY_LOCAL_MACHINE\SOFTWARE\Autodesk\Inventor\RegistryVersion17.0\LicenseMode

Inventor release 2014:
HKEY_LOCAL_MACHINE\SOFTWARE\Autodesk\Inventor\RegistryVersion18.0
Change values for the Value keys below:
LicenseType  from Network License change to Stand-Alone License
LicenseMode from 1 change to 2
Or this can also be done the other way around.

Via Up and Ready and TS17847202

Above solution does not apply to Multi-flex or eFlex installations.  Do NOT switch licenses when using either of these two licensing methods.

See also Change AutoCAD 2013 from Network license to Standalone as well as for AutoCAD 2011 and AutoCAD 2012

AutoCAD registry details explained

No comments:

Post a Comment