Thursday, November 8, 2012


If you are using MASSPROP and an AutoCAD 2013 based product this hotfix is for you.

According to DL20864100 from where you can download it: Autodesk MASSPROP Hotfix. This hot fix addresses an issue with the MASSPROP command returning an error or invalid results on certain solids created by extruding regions along closed polylines.

This hotfix applies to the Service Pack 1 or 1.1 levels of AutoCAD 2013 and AutoCAD 2013-based vertical products: AutoCAD 2013, AutoCAD Architecture 2013, AutoCAD Civil 3D 2013, AutoCAD ecscad 2013, AutoCAD Electrical 2013, AutoCAD Mechanical 2013, AutoCAD MEP 2013, AutoCAD P&ID 2013, AutoCAD Plant 3D 2013, AutoCAD Raster Design 2013 and AutoCAD Structural Detailing 2013

No comments:

Post a Comment

Subscribe to the comments feed

Some of the latest blog posts

Subscribe to RSS headline updates from:
Powered by FeedBurner

Contact Us | About JTB World | Subscribe to this blog
JTB World's website | Website General Terms of Use | Privacy Policy
^ Top of page

© 2004- JTB World. All rights reserved.