Friday, April 13, 2012

acad.exe The application was unable to start correctly (0xc0000043)

I’ve seen this error with AutoCAD Architecture 2013. So far the only solution has been to try starting ACA 2013 a second time when it usually works fine.

acad.exe - Application Error: The application was unable to start correctly (0xc0000043). Click OK to close the application.

I tried to run the three executable below this folder \3rdParty\x86\VCRedist\ on the installation media and since then I’ve not seen this error. But unfortunately this did not help as I later on got the error again.

No comments:

Post a Comment

Subscribe to the comments feed

Some of the latest blog posts

Subscribe to RSS headline updates from:
Powered by FeedBurner

Contact Us | About JTB World | Subscribe to this blog
JTB World's website | Website General Terms of Use | Privacy Policy
^ Top of page

© 2004- JTB World. All rights reserved.