Friday, December 26, 2008

DWG TrueView object snaps available on the command line

Autodesk’s DWG TrueView have some inquiry object snaps available with you want to measure a distance or area. TT (Temporary Track Point), FROM, M2P (Mid Between 2 Points), EXT (Extension),  and point filters .X, .Y, .Z, .XY, .XZ, .YZ are only available on the command line and not so obvious unless you know about them.

Image below is from DWG TrueView 2009 with the object snaps available on the Ribbon.

No comments:

Post a Comment

Subscribe to the comments feed

Some of the latest blog posts

Subscribe to RSS headline updates from:
Powered by FeedBurner

Contact Us | About JTB World | Subscribe to this blog
JTB World's website | Website General Terms of Use | Privacy Policy
^ Top of page

© 2004- JTB World. All rights reserved.